Advice regarding the first wash cycle – Hotpoint Ariston LFF 8214E User Manual

Page 3

Advertising
background image

EN

3

Electrical connection

Before inserting the plug into the electrical socket, make sure
that:

• The socket is earthed and complies with current

regulations.

• The socket can withstand the maximum load of the

appliance, which is indicated on the data plate located on
the inside of the door (see chapter entitled Description of
the appliance).

• The power supply voltage falls within the values indicated

on the data plate on the inside of the door.

• The socket is compatible with the plug of the appliance. If

this is not the case, ask an authorised technician to replace
the plug (see Assistance); do not use extension cables or
multiple sockets.

Once the appliance has been installed, the power supply

cable and the electrical socket should be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be replaced

by the manufacturer or its Technical Assistance Service in order
to prevent all potential hazards. (See Assistance)

The Company shall not be held responsible for any

incidents that occur if these regulations are not observed.

*

Only available in selected models.

Technical data

Dimensions

width 60 cm
height 85 cm
depth 60 cm

Capacity

14 standard place-settings

Water supply
pressure

0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi

Power supply
voltage

See appliance data plate

Total absorbed
power

See appliance data plate

Fuse

See appliance data plate

This dishwasher conforms to
the following European
Community Directives:
-2006/95/CE dated 16/01/2007
(Low Voltage) and subsequent
modifications
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent modifications
-97/17/EC (Labelling)
-2002/96/ CE Waste Electrical
and Electronic Equipment
(WEEE)

Anti-condensation strip

*

After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order to
protect it from any condensation which may form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add only then approximately 1 kg of salt (see
chapter entitled Rinse aid and refined salt). The water may
overflow: this is normal and is not a cause for concern. Select
the water hardness value (see chapter entitled Rinse aid and
refined salt).

-

After the salt has been poured into the

machine, the LOW SALT indicator light

*

switches off.

If the salt container is not filled, the water softener and the

heating element may be damaged as a result.

Advertising