Replacing and cleaning the dust filter – Acer P1223 User Manual
Page 49
40
Eng
lish
English
Replacing and cleaning the dust filter
1
Turn the projector off then unplug the power cord.
2
Pull the dust filter out (Illustration #1).
3
Clean or replace the dust filter.
4
To put the dust filter back, reverse the previous steps.
Cleaning the dust filter
Clean the dust filter after every 1000 hours of use. If it is not cleaned periodically, it
can become clogged with dust, preventing proper ventilation. This can cause
overheating and damage the projector. (Normally 1000 hours is recommended,
however the period will vary depending on actual environment.)
Please follow these steps for cleaning procdure:
1
To clean the dust filter, use a small vacuum cleaner designed for computers
and other office equipment. It also can be cleaned using water. (Illustration #2)
2
If the dirt is difficult to remove or the filter is broken, please contact your local
dealer or service center to obtain a new filter.
(Illustration #1)
2
Dust Filter
(Illustration #2)