Xylem PG300 DIGITAL PRESSURE GAUGES User Manual

Pg300

Advertising
background image






PG300

Digital Pressure Gauge Operating Instructions


Operating/Mounting Instructions

1. Mount the gauge on a suitable (or appropriately sized) NPT female fitting. Use Teflon Tape or

Pipe Dope. Do not over tighten.

2. Depress ON/OFF button to power up unit (no pressure applied). If there is a reading other than

zero, press the ZERO RESET button to zero-out the display. Press the On/Off button to switch
to the desired pressure scale.

3. Apply pressure to the gauge - the display should now indicate the pressure being applied.

Note: If the Zero Button is pressed when the pressure is changing, the display will not indicate

"0" (no pressure applied). Press the ZERO button to Zero-out the display once the pressure
has been stabilized

4. Press the ON/OFF button to shut off display. Note: The display will automatically turn off after

approximately 3 minutes

5. Battery Replacement: The battery is located within the inside of the rear cover. Remove the

screw to remove the rear cover. Using a small screwdriver to slide the battery out un-snap the
old 9V battery and replace with the new battery. Replace the rear cover and the screw when
complete.









Advertising