Hotpoint Ariston Aqualtis AQ93F 29X User Manual

Page 3

Advertising
background image

EN

3

65 - 100 cm

Connecting the drain hose

Connect the drain hose to
drain duct piping or a wall
drain located between 65
and 100 cm above the floor,
making sure it is not bent
at all.

Alternatively, rest the
drain hose on the side of
a washbasin or bathtub,
fastening the duct supplied
to the tap (see figure).
The free end of the hose
should not be underwater.

! We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.

Electrical connections

Before plugging the appliance into the electricity socket,
make sure that:

• the socket is earthed and complies with all applicable

laws;

• the socket is able to withstand the maximum power load

of the appliance as indicated in the Technical data table
(see opposite);

• the power supply voltage falls within the values indicated

in the Technical data table (see opposite);

• the socket is compatible with the plug of the appliance.

If this is not the case, have the socket or the plug
replaced.

! The appliace must only be installed indoor in a frost free
and dry room, to prevent it from electronic damage due to
frost or condensation.

! The mains socket must remain within easy reach after the
washing machine has been installed.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable and plug must only be replaced
by authorised technicians.

Warning! The company shall not be held responsible in the
event that these regulations are not respected.

Technical data

Model

AQ93F 29 X

Dimensions

width 59.5 cm
height 85 cm
depth 64,5 cm

Capacity

from 1 to 9 kg

Electrical
connections

please refer to the technical data plate
fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 71 litres

Spin speed

up to 1200 rotations per minute

Test wash cycles
in accordance
with directives
1061/2010 and
1015/2010.

programme

; temperature 60°C;

programme

; temperature 40°C.

This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compa-
tibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC

Advertising