Alpha Technologies FXM Communication - Manual (Page 10)

8
FXM Communication Manual
If the UPS has the optional, factory-installed FXM Communication Module present, then you
can use the internet or a company intranet to communicate with the unit. You can then monitor
and control the UPS with a web browser (See Figure 4. below) or with SNMP protocols.
4.1 Installation and Set Up
In order to successfully complete this procedure, you should have working
knowledge of network protocols and how to set them.
Tools and Materials Required
Computer with network card and web browser.
Cross over cable or hub.
The UPS’s: Final IP Address and Subnet Mask and if needed the Default Gateway
and the DNS Server addresses.
•
•
•
4 Ethernet Communication
Figure 4.
FXM Ethernet Communication (UPS Specification Screen Shown)
Screen
Selection
Menus
UPS
Operating
Mode
Fault and
Alarm
Indicators
Readout
Screens