Alpha Technologies INEX 100A STS Module and MBS+PDU - Manual (Page 7)

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This section contains important instructions that should be followed during the installation and maintenance of
equipment and batteries. Please read all of the instructions before operating the equipment, and save this
manual for future reference.
The following safety symbols will be found throughout this manual, carefully read all information and abide by the
instructions:
DANGEROUS VOLTAGE
This symbol indicates a dangerous voltage
exists in this area of the product.
GAS HAZARD
This symbol indicates a gas hazard
exists in the area of vented batteries.
NO MATCHES OR OPEN FLAMES
This symbol indicates a fire or explosive hazard
exists in the area of the product.
The following levels of warning will be used with the above symbols:
DANGER: You WILL be KILLED or SERIOUSLY INJURED if instructions are not followed closely.
WARNING: You CAN be KILLED or SERIOUSLY INJURED if instructions are not followed closely.
CAUTION: You CAN be INJURED or equipment can be DAMAGED if instructions are not followed closely.
Before using the product, read all instructions and cautionary markings on the product and any equipment
connected to the product.
This unit is designed for indoor use only. Do not expose the product to rain or snow; install only in a clean, dry
environment.
CAUTION – To reduce the risk of fire hazard, do not cover or obstruct the ventilation openings. Do not install the
inverter in a zero-clearance compartment.
CAUTION – Unless otherwise noted, use of an attachment not recommended or sold by the product manufacturer
may result in a risk of fire, electric shock, or injury to persons.
CAUTION – Do not operate the product if it has received a sharp blow, it has been dropped, or otherwise
damaged in any way – return it to a qualified service center for repair.
CAUTION – Do not disassemble the product – call our qualified service centers for servicing. Incorrect
reassembling may result in a risk of electrical shock or fire.
WARNING – The input and output voltages of the product are hazardous. Extreme caution should be maintained
when servicing or touching conductive components connected to the product.
Mechanical Safety
Power equipment can reach extreme temperatures under load.
Use caution around sheet metal components and sharp edges.