AVTECH Digital Temp & Humidity Sensor (RMA-DTH-SEN) - Manual

The External Digital Temperature/Humidity Sensor is a digital sensor designed to monitor both the
temperature and humidity of a specifi c location. Its small size (i.e. 2˝ long, 3/8˝ diameter) allows it to be
installed anywhere temperature or humidity issues threaten valuable equipment. The Digital Temperature/
Humidity Sensor is designed specifi cally for use with the Room Alert.
Mount the Digital Temperature/Humidity Sensor where desired and run the sensor cable back to the ID
Box. Plug the RJ-11 end of the sensor cable into an available RJ-11 port on the front of the Room Alert
4E, Room Alert 7E, Room Alert 11E, Room Alert 24E, Room Alert 26WO, Room Alert 26W, Room Alert
32E or Room Alert 32W ID Box.
If desired, the sensor cable for the Digital Temperature/Humidity Sensor can be extended beyond the
default 25 foot length. The maximum supported extension length is 100 feet and the cable that is used
for the extension must be ‘straight through’. Be sure to connect the wires in the exact confi guration they
were in before extension if manufacturing your own cables. The Digital Temperature/Humidity Sensor
provided is ‘Volt-Free’.
Room Alert Digital Temperature/Humidity Sensor
Instructions For Installing The External Digital Temperature/Humidity Sensor
AVTECH Software • Phone 401.628.1600 • Sales 888.220.6700 • Fax 401.628.1601 • Web AVTECH.com
Application Note
Room Alert
The Digital Temperature/Humidity
Sensor is installed by inserting the
RJ-ll end of the sensor cable into an
available RJ-11 port on the front of
select Room Alert ID Boxes.
© 1988 - 2011 AVTECH Software, Inc. All Rights Reserved.
The Screw Connectors On The Sensor ID Boxes Are Volt-Free Contacts Only. Do Not Connect These Terminals To Any Live Circuit.
A Qualifi ed Electrician Should Be Consulted To Test Any Wires You Connect To The Room Alert ID Box For The Presence Of Electrical
Voltages And If Any Are Detected, They Must Not Be Wired To The ID Box. The ID Box May Become Dangerous If You Connect It
To A Live Circuit. Never Connect Main Power To Any Of The Room Alert Sensors Unless Specifi cally Instructed To Do So Using The
AVTECH Software 5V Power Adapter. If Required, An AVTECH Software 5V Power Adapter Will Be Included With That Sensor.
DO NOT Use Switch Sensors In ‘Explosive’ Environments Unless Approved For Those Environments.
IMPORTANT SAFETY NOTICE