AVTECH Digital Temperature Sensor (TMP-SDT-SEN) - Manual

AVTECH Software, Inc. Temperature & Environment Monitoring… Made Easy! AVTECH.com
Digital Temperature Sensor (TMP-SDT-SEN)
Installation Note
RJ-11 Extension Cable & Coupler
ECC-25E-SEN
AVTECH’s Digital Temperature Sensor monitors ambient indoor temperature in real time. The
2" L x 3/8" diameter sensor housing is small and light-weight enough to
install almost anywhere with no special tools.
With an operating range of -40º to 185º Fahrenheit (-40º to 85º
Celsius), this “Plug and Play” sensor provides values accurate
to +/- 0.125 degrees every 2 seconds to your Room Alert or
TemPageR monitor.
Digital Temperature Sensor Package Contents
• One (1) Digital Temperature Sensor with built-in 25' RJ-11 cable
• One (1) Installation Note (You’re reading it now.)
Install Your Digital Temperature Sensor
1. Locate the sensor (the end with the red cap) where
you wish to measure temperature. Shown here is a
Digital Temperature Sensor placed behind a server
rack to monitor hot air exhaust.
2. If necessary to hold the sensor in place, mount it with
a cable clip, Velcro or nylon tie.
3. Run the built-in 25' cable back to your Room Alert, TemPageR or Wireless Sensor Hub.
Try to avoid running it near large electromagnetic
devices or fluorescent lights, which produce EMI that can
interfere with sensor readings.
4. Plug the RJ-11 jack into an RJ-11 port on your Room
Alert or TemPageR monitor.
RJ-11 Extension Cable & Coupler (ECC-25E-SEN)
You may extend the Digital Temperature Sensor up to
100' away from your Room Alert, TemPageR or
Wireless Sensor Hub. AVTECH stocks the 25' RJ-11
Extension Cable & Coupler (ECC-25E-SEN), shown
here, for this purpose. Please contact your Product
Specialist to purchase this extension cable.
Do not use the Digital Temperature Sensor in hazardous (classified) locations or
life/safety applications.