Baldwin Longview Handleset - Full Dummy - Manual

Note: use longer screws
supplied in Thick Door Kit
for doors 2" (51mm) up to
2-1/2" (64 mm)
Only use if included
in the box.
Full Dummy Handleset Installation Instructions
Fits 1-3/4" (44 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
Centerline
Ligne médiane
Linea central
2-3/8" 60mm
2-3/4" 70mm
2-3/8" 60mm
2-3/4" 70mm
Centerline
Ligne médiane
Linea central
Fold
Doble
Plier
Fold
Doble
Plier
5-1/2" 140mm
8-13/32" 214mm
www.baldwinhardware.com • Customer Service 1.800.437.7448
TEMPLATE
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
1. Install trim
2. Install knob/lever
Please note: Product illustrations
may differ from your product.
Installation is the same.
Place lever or knob onto chassis and turn set screw clockwise to secure.
The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.
47041 / 01
Copyright © 2011 Baldwin Hardware Corporation
1"
25mm
1"
25mm
1"
25mm
Measure
after printing.
Mesurer après
imprimer.
Medida después
de la impresión.
The drilling template must be printed
to scale to ensure correct hole
placement. To confirm correct print
scale, the square below must measure
exactly 1" by 1" (25mm x 25mm).
Le gabarit de perçage doit être
imprimé à l’échelle pour assurer le
placement correct des trous. Afin de
confirmer que l’échelle soit correcte,
le carré ci-dessous doit mesurer
exactement 1" x 1" (25mm x 25mm).
La plantilla de perforación deben estar
impresos a escala para confirmar la
correcta colocación de los agujeros.
Con el fin de confirmar que la escala
de impresión es correcta, el cuadrado
de abajo debe medir exactamente
1" x 1" (25mm x 25mm).