Baldwin Soho Sectional Handleset - Manual

fold line fold line
fold line fold line
Sectional Handleset used with Keyless Entry Deadbolt
Installation Instructions
Congratulations! With your purchase of this Premium Entrance
Set, you’re among a group of discerning individuals who know the
intrinsic value of selecting the finest—Baldwin.
Our step-by-step installation instructions will help guide you
through your project quickly and easily.
Before you begin your installation, read and understand the
installation instructions and marking templates. If you have any
questions, please do not hesitate to contact our Baldwin Consumer
Help Line at 1-800-566-1986. We’re here to help! We thank
you for your purchase and wish you the fullest enjoyment of your
Baldwin product.
WARNING: Do not attempt to clean your hardware with any
type of abrasive cleaners, solvents, or chemicals. These types of
cleaning agents may mar the finish. A damp cloth is all that is
necessary to wipe clean.
Note: Finish Number 102, Oil-Rubbed Bronze, can be cleaned with
light machine oil and wiped with a dry cloth.
BEFORE YOU BEGIN
• This product does not contain deadbolt components
and is to be used with a Baldwin Keyless Entry
Deadbolt. Please refer to the Keyless Entry Deadbolt
product for installation instructions.
• Remove and discard all materials and screw(s) used for
packing your Premium Entrance Set. Verify that you have all
parts pictured on exploded view section of instructions.
• Follow the step-by-step sequence to ensure proper operation
of your Baldwin lockset.
• If your door is pre-drilled, skip Door Preparation.
• We recommend spreading cardboard over floor to prevent
scratching parts and marring floor.
• Always wear protective eye wear.
PK.9009 02/2010 DOOR PREP
EXPLODED VIEW
Consumer Help Line
1-800-566-1986
Hours: 8 a.m. to 8 p.m. E.S.T. – Monday - Friday
10 a.m. to 6 p.m. E.S.T. – Saturday
If you have trouble installing your Baldwin product, feel free to call
our toll-free Consumer Help Line.
*Supplied with Keyless Entry Deadbolt product
EXTERIOR TRIM
1. Install latch (A) with latch screws (B). Predrill screw holes for
ease of installation using 1/8” bit.
2. Secure exterior subassembly (C) with retainer (D) and lower
pull screw (E).
ADJUSTING BACKSET
Grasp faceplate and rotate 180° for 2-3/4” backset.
A
B
C
D
E
fold line fold line
©2010 Baldwin Hardware Corporation, Lake Forest, CA 92610 PK.9009 (2/10)