Carlon Split Duct - Low Res - Manual

Made in the U.S.A.
Split Duct
www.carlonsales.com
Carlon Split Duct is the fast and easy way
to repair broken ductwork without the costly
cutting and resplicing of your conductors.
Our unique tongue-and-groove design leads
the industry in providing a strong, rigid
solution for duct repair situations.
The interlocking design allows the split duct
sections to be staggered and butted together.
Joints may be sealed with tape and reinforced
with plastic or metallic straps to produce a
rigid, stable unit.
Manufactured from a compound designed
specifically for power and telecommunications
applications, Carlon Split Duct exhibits
superior impact strength and ultraviolet
resistance.
Available in 2" through 6" diameters, this
product line also contains couplings and
sweeps necessary to complete the system.
Carlon ® Split Duct
The fast and easy method of installing duct around existing
cable for repair and temporary installations.
Recommended Installation Procedure
1. Place one 10-foot Split Duct section under cable.
2. In order to stagger joints, saw another section in half (about 5 feet
long).
3. Place 5-foot sectIon over cable and snap the two sections together.
4. Place strap about one foot from the end and another strap about a
foot from the joint where the ends of the top sections will butt.
5. Place another 10-foot Split Duct section over the open half of the
bottom section, butt the ends tightly together and snap the sections
together.
6. Place a length of tape around both sections of the Split Duct to cover
the butted joint.
7. Place a strap about one foot beyond the taped joint.
8. Lay another length of Split Duct underneath cable, butt together, tape
the butted joint and strap one foot on each side of the joint.
9. Repeat procedure.
56
Gross Automation (877) 268-3700 · www.carlonsales.com · [email protected]