BARSKA AX11902 - Fireproof Digital Keypad Safe - Manual

OPENING THE SAFE WITH ACCESS KEY
1. Remove the small cover by gently pulling on it, to expose the
access key slot
2. Insert the access key and turn key to the left to unlock
3. Turn handle to the right to open safe door
4. Turn access key to the right to lock, remove key and replace
small plug
NOTE
Store access keys in a secure place. NOT inside of safe
BATTERIES
1. Remove battery cover on the inside of the safe door
2. Insert 4 AA batteries into the battery compartment and pay
attention to the polarity of the batteries
3. Replace compartment cover
REPLACING BATTERIES
If LCD displays LO BAT, this indicates that the batteries are low.
1. Open safe by using the access key
2. Repeat steps 1-3 of “Batteries” above and replace old batteries
with new batteries
3. Close safe and ensure that the safe is locked
NOTE
After reinserting batteries safe retains last personal pin codes
saved
CREATING PERSONAL PIN CODES
For security purposes, change the factory default codes as soon as
possible and before placing valuables in the safe.
NOTE
1st default pin code is 1234
2nd default pin code is 123456
NOTE
Safe retains only two 3-8 digit pin codes
1st Personal Pin Code
1. Open safe either by default pin codes or access key
Note: A beep will sound for each key pressed
2. Input the factory preset pin code #1234# then press * button
rapidly, on the LCD screen one dash will be blinking
3. Input your personal pin code, press # to confirm the LCD
screen will show -----, input digit pin code again, press # to
confirm
4.“Into” appears in the LCD screen which indicates that your pin
code is saved
2nd Personal Pin Code
For security purposes you must change the 2nd pin code set
1. Press #123456# then press * button rapidly, on the LCD screen
one dash will be blinking
2. Follow steps 3 and 4 of “1st Personal Pin Code”
NOTE
Be sure to write down these codes immediately and store in a
safe place
TESTING THE PERSONAL PIN CODES
1. With safe door open, and the handle in the locked position.
Press # and enter in 1st set of the personal pin code on the key
pad and press # again
Successful Save
- You will hear 3 short beeps
- The LCD screen will show OPEN
- Move handle to the right to retract bolts
Unsuccessful Save
- You will hear a consistent beeping
- The LCD screen will show ERROR
- Handle will not move
- Repeat steps Creating Personal Pin Codes, of 1st Personal
Pin Code
2. To test 2nd personal pin code. Press # and enter in 2nd set of
the personal pin code on the key pad and press # again. See
“ Successful Save” and “ Unsuccessful Save” above
3. Close safe and ensure that the safe is locked
OPENING SAFE WITH PERSONAL PIN CODES
1. Press # then input either of the personal pin codes then press #.
2. Turn the handle to the right and pull the safe door open
NOTE
After entering pin, you have 5 seconds to turn the knob before the
mechanism re-locks automatically
3. To close safe, close door and turn knob to the left to lock
See reverse side for more information
9/12
BC246
Parts of the Control Panel
C. LCD Screen
D. Key Pad
A. Handle
B. Override Key and Cover
Parts of the Inside of the Safe Door
E. Initialization Button F. Battery Compartment
A
C
E
F
B
D
WARNING: Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe, gaining full access
to the safe and contents.
PARTS OF THE SAFE
User Manual For
Fireproof Digital Keypad Safe