HKC security GSM-Q (Plug on) - Manual

ARM
A
Part sets system
A
ARM B
Part sets system B
SET
A
Same as
ARM
A
(if you prefer to use the word “set”)
SET B
Same as
ARM B
(if you prefer to use the word “set”)
FORCE
This forces the panel into the Set mode and inhibits any open zones, tampers or faults
FORCE
A
This forces the panel into the Part-Set
A mode and i
nhibits
any open zones, tampers or faults
FORCE B
This forces the panel into the Part-Set B mode and i
nhibits
any open zones, tampers or faults
Note:
Ask your installer if you are permitted to inhibit zones, tampers and faults
Alternatively you can inhibit zones and tampers with the following commands... SET **
Inhibits all open zones before setting the system
SET ##
Inhibits all open tampers before setti
ng the system
SET *3
Inhibits a specific zone (in this example zone 3)
SET *z3
This command is the same as set *3 above
SET *z03
This command is the same as set *3 above
SET *z003
This command is the same as set *3 above
SET #3
Inhibits a specific tamper circuit (in thi
s example tamper 3)
SET #z3
This command is the same as set #3 above
SET #z03
This command is the same as set #3 above
SET #z003
This command is the same as set #3 above
SET *p80
Inhibits a specific point-zone (in this example point 80)
SET #p80
Inhibit a specific point-tamper (in this example poi
nter 80)
Other com
mands
Note:
There is a one hour security lockout after seven w
rong
text commands and/or user codes
!