Burke Flooring Mercer Mouldings – Transitions, Joiners Reducers, Corner Guards Installation User Manual

Installation, maintenance and warranty data, Installation, Maintenance

Advertising
background image

Installation, Maintenance and Warranty Data

RESILIENT TILE ACCESSORIES

Burke Flooring Products, a Division of Burke Industries

2250 South Tenth Street, San Jose CA 95112

(408) 297-3500 E: Burkeflooring.com

Mercer Mouldings – Transitions, Joiners Reducers and
Corner Guards


Installation

Generally Burke Transition Mouldings are glued, nailed, tacked or stapled into place. There are
many products in this line and they all have various ways they can be installed. Each application

may have different installation requirements, depending on that particular job situation. If you have
any general or specific installation questions please contact your Burke Flooring representative.

Maintenance

Mild soap and water should readily clean Burke Transitional Mouldings. A polish or wax is not

necessary. However, a liquid floor polish can be used if a glossy shine or extra protection is desired.
Wax or coatings from adjacent polished surfaces will not harm Burke Transitional Mouldings.

Warranty

• BurkeMercer Mouldings: 2 Year Limited

ALL PRODUCTS WILL:

• Be free from defects in material and workmanship at the time of shipment.
• Conform, to commercially acceptable standards, for size and color as shown in Burke’s catalog.

• Be sufficiently packaged and labeled
• Not wear out within their respective warranty periods if properly installed and maintained.

WARRANTIES WILL BE VOID IF:
• Burke Flooring Adhesives are not used
• Products are not installed and maintained according to Burke flooring instructions

• Products are not first quality (i.e. seconds, imperfects)

CONDITIONS OR AFFECTS NOT WARRANTED:

• Exact color or pattern matches
• Color degradation caused by sunlight or other excessive U.V. rays

• Any indentation caused by high heels or any other force exceeding 600 p.s.i.
• Problems caused by excessive moisture, hydro-static pressure, or alkali
• Abuse or abnormal conditions

• Exterior applications

WARRANTY TERMS: Any defects must be reported to Burke Flooring within 30 days after the

discovery of defect. Always dry lay mouldings before installation to inspect for defects. Burke
Flooring will not be liable for labor to remove and reinstall defective products that could have been
replaced before installation. Burke Flooring reserves the right to inspect all claims against our

warranties. Burke Flooring will not be liable for shipping costs of assumed defective products if the
product is found not to be defective. Burke Flooring does not warranty any implied promise or
guarantee by any salesperson or representative. Any special condition warranties must be in

writing from Burke’s president.

Advertising