Hunter 21375 46 Stonington - Manual (Page 12)

12
42671-01 • 05/27/10 • Hunter Fan Company
WARNING: Use only the light fixture supplied with this fan model .
7-1 . To attach the upper switch housing, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate .
7-2 . Align the keyhole slots in the housing with the housing
assembly screws .
7-3 . Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole
slots . Install the remaining #6-32 x 3/8” screw into the housing .
Tighten all three screws firmly .
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate . Failure to properly
attach and tighten all three assembly screws could result in the switch
housing fixture falling .
7-4 . To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly .
Note: Both plug connectors are polarized and will only fit
together one way . Make sure the connectors are properly
aligned before connecting them . Incorrect connection could
cause improper operation and damage to the product .
7-5 . Place the lower switch housing assembly over the upper switch
housing . Align the side screw holes in the upper and lower
switch housings . Attach the lower switch housing to the upper
switch housing with three #6-32 x 3/8” housing assembly screws .
Steps 7-1 – 7-3
Housing
Assembly
Screw
Housing
Assembly Screw
Lower Switch
Housing
Plug
Connector
Plug
Connector
Detail
Steps 7-5 – 7-6
Upper
Switch
Housing
7 • Completing Your Installation With a Multi Staked Light Fixture