Analog Way QuickVu User Manual

Quick start guide, Quickvu, Ref. qvu150

Advertising
background image

QuickVu

- Ref. QVU150

QUICK START GUIDE

Thank you for choosing

Analog Way

and the QuickVu. By following these simple steps, you will be able to set

up and use your powerful Dual Scaler Hi-Resolution Seamless Switcher based on

Analog Way

’s new Midra™

platform within minutes. Discover the QuickVu capabilities and intuitive interface while configuring your first

show and unleash your creativity for a new experience in show and event management.

• 1 x QuickVu (QVU150)

• 1 x Power supply cord

• 1 x Ethernet cross cable (for device update)

• 1 x Remote Control Software (RCS²)*

• 1 x Set of 6 audio 5-pin screw terminals

• 1 x Front Rack Ears (the parts are stowed in the packaging foam)

• 1 x User Manual (PDF)*

• 1 x Quick Start guide*

* User manual, quick start guide and the RCS² are available on

www.analogway.com

WHAT’S IN THE BOX

QUICK INSTALL AND SETUP

Getting started:

You may wish to reset the unit to factory settings to get

started. Go to: Menu > Control > Reset/Erase > Default

Values > Yes

1.

Select the Output resolution that matches the native

resolution of your display. You will next be prompted to

choose enable follow mode if desired and output rate.

Menu > Output > Output format > 1920x1080 >

Internal Ref > 60 Hz

2.

Inputs can be configured automatically using the Auto

Set All function. Menu > Intputs > AutoSet All > Yes

It will scan each input and detect the sync type that is

plugged in. You can still do an Autoset or manual setup per

input.
The QuickVu has 2 layers available called: LAYER A and

QUICK FRAME.

3.

To display a source, select a source (it will blink). Press

TAKE to transition your source from Preview to Program

output.
To view on Preview or change the contents of a different

source, simply select it. Only 1 layer can be seen on the

Preview.

4.

To clear the layer select BLACK. Press TAKE to remove

the layer from the Program output.

TIP:

If you would like the Program and Preview to toggle/

flipflop during each Take, enable this feature by going to

Menu > Control > Functions > Preset Toggle.

Once enabled, the old Program output will become the

new Preview after each Take.

5.

See the next page which describes the button lighting

color code and other front panel features.

QuickVu can be used to display:

- sources seamlessly switched in the LAYER A.

IMPORTANT:

Simply selecting a menu item will not set it

to that value. Be sure to press the ENTER button when

setting the menu items.

CAUTION!

If required, front handles of the

device can be dismantled, but

with caution. The original screws

removed must not be reintro-

duced to their location without

handles in place. Substantial da-

mages can occur, including risk of

electric shock from the mains vol-

tage. Only M4x12mm screws can

be used. (They are supplied with

the unit.)

Advertising