eLine Technology SOLAR-Charge Controller User Manual

eLine Technology Power suppliers

Advertising
background image

Renogy Charge Controller Model No. PWM10CC

1

30 AMP PWM CHARGE CONTROLLER MANUAL

Charge Controller Specifications

Technical Information (12/24V Auto Mode)

12V

24V

Rated Solar Input

30A

30A

Related Load

30A

30A

25% Current Overload

1 minute

1 minute

Load Disconnect

11.1V

22.2V

Load Reconnect

12.6V

25.2V

Equalization Voltage (30 minutes)

14.6V

29.2V

Boost Voltage (30 minutes)

14.4V

28.8V

Float Voltage

13.6V

27.2V

Temperature Compensation (mV/C)

-30mV/C

-60mV/C

Terminals

For wire sizes up to 6mm

2

Temperature

-35°C to + 55°C

Battery type

Lead Acid batteries, including AGM and Flooded

Table 1. Charge controller technical information

Quick Start Instructions

This section provides a brief overview of how to begin using your solar charge
controller. It is recommended that each user review the entire manual to ensure the best
possible performance as well as maximize years of worry-free service. It is highly
recommended that the connections be made in the following steps provided:

1. Mount the charge controller onto a clean, vertical flat surface. It is very important

to allow enough space both above and below the charge controller to ensure
maximum air flow.

2. After proper mounting is established, connect the battery to the charge controller

terminals. Be careful not to switch the polarities of the battery and do not allow
the bare wires to touch the metal casing of the charge controller.

3. Connect the solar (PV array) with the MC4 adapter kit cables. The green LED

indicator will light up if there is enough sunlight.

4. Optional: Connect the load if you have a 12VDC application. If the red LED

indicator light turns on, the battery capacity is low and needs to be charged
before completing the system installation.

eLineTechnology.com

Advertising