eLine Technology SIP Alarm Settings Guide - Manual

Before doing the following steps, be sure the testing of hardware (alarm
–in and alarm-out device) is OK.
1: How to receive the alarm-in signals on VMS software?
You can do it as follows:
(1). Configure “Alarm Center”.
Set the IP of the PC where the VMS software runs on as the Alarm Center
Server IP, and set the port it listen to. Port 30004 is used in default.
(2). Listen to the port
Open a socket to listen to the port you set in the last step. If you can receive
the alarm-in signals from the IP camera, you can parse the alarm-in message
as the sample code did in the attachment. The sample code bind the local PC
and listen to 30004, you can modify it.
Note:
a. Our NVMS software listens to port 30004 in default. If you select this
port as the alarm port, you
’d better close NVMS when testing in order to
avoiding port conflict.
b. We can mainly deal with two types of alarm: I/O and motion detection.
If you want to test the I/O alarm, you
’d better disable the motion
detection.
2. How to make the alarm-out work after receive the alarm-in signals?
eLineTechnology.com 1