eLine Technology ANPTZ-Controller - Manual

3
Preset Point Preset Point
2
Set target camera address Set target camera address
I R R e m o t e C o n t r o l l e r
1
Installation
IR REMOTE CONTROLLER GUIDE
Connect 485 port to PTZ dome 485 cable,
Connect DC12V to power port.
After power on, controller will display
or
means address of command, 001 is
address number.
means preset point, 001 is preset number.
A001
P001
A
P
Press button go to address command mode.
It is a command of selecting your target camera,
At this mode, you can input a number by press
keyboard numeric key,
If you want input a number more than 10,
You need press
button change to plus 10
mode. You can input 3 number at this mode.
After enter you need input
button
confirm it.Press button do backspace.
At any mode, if you press button, system will
go to address input mode.
If you only want change a address number below
10, you only need press
one time. numeric key
CAM
-/--
ENTER
C
ESC
Press button go to preset selecting mode.
It is a command of selecting preset of your
target camera,
At this mode, you can input a number by press
keyboard numeric key, this is preset number
If you want input a number more than 10,
You need press
button change to plus 10
mode. You can input 3 number at this mode.
After enter you need input
button
confirm it. Press button do backspace.
If you want set a preset number, you need
press
button 3 seconds, and controller
will display , at this time you can input a
number, if you need input a number more
than 10, you need press
button at first.
After input number, need press key
confirm it.
If you want clear a preset number, you need
press
button 3 seconds, and controller
will display , You can input number same
as set preset.
You can use same way set / clear / go to
and
(left limited point) (right limited point)
SHOT
-/--
ENTER
C
PRSET
SET-
-/--
ENTER
DELETE
CLR-
HOME
A B
485 B/-
485 A/+
FOCUS+
FOCUS- ZOOM-
ZOOM+ FOCUS+
IRIS
CLOSE
OPEN
-/--
SETUP
DISP
C
A B
ESC
HOME RUN
PATTERN PRSET
SHOT CAM
DELETE
F4
P1
S1
P5
SPEED AUTO
S4 S3 S2
F3 F2 F1
P4
P8
P3 P2
P7 P6
Protocol :Pelco-D
Bitrate:2400bps Protocol :Pelco-D
Bitrate:2400bps