EXP Computer ThinLan 110 - Manual

INTRODUCTION
This ThinLan is a credit-card-size Type II ThinLan card complies with the
PCMCIA Release 2.1 specification and supports IEEE 802.3u(100BaseT) and
802.3(10BaseT) standards. This adapter is designed to give you years of trouble-
free and reliable service. The drivers come with this card allow you to use the
most popular network Operating System (NOS) in the PC environment easily.
SYSTEM REQUIREMENTS
1. Notebook or desktop computer with a PCMCIA 2.1 Type II slot.
2. PC Card (PCMCIA/JEIDA) Card service and Socket device driver compliant
preferred. (If the drivers are not present, the Point Enabler for Intel 82365SL
Personal Computer Interface Controller PCIC or compatible will be installed.
(MS-DOS system)
3. One of the following Operating Systems: DOS Version 5.0 or higher, Windows
3.x, Windows 95, or Window NT Version 3.51, 4.0.
4. Network Operating System specific files. (depending on your Network type)
HARDWARE INSTALLATION
1. Connect the cable of the ThinLan PC Card with the PC Card. (Note: the 15-
pin keyed connector can be easily attached to the card if you are plugging it
with the right side up. )
2. Locate the PCMCIA slot. If you are not sure of this, consult your computer’s
user manual for the location of the PCMCIA socket.
3. Align the ThinLan PC Card with the arrow sign pointing toward the computer
s socket. And you can also see the card is keyed to guide the proper
installation.)
4. Slowly insert the Ethernet card into the slot and press firmly until the Ethernet
connector is seated.
5. Hardware installation is now completed. The Ethernet card will obtain power
directly from the computer. You are now ready to install the ThinLan PC Card
device driver.