ELRO HA68S Multi-zone professional alarm system QUICK GUIDE User Manual

Ha68 quick guide

Advertising
background image

HA68 QUICK GUIDE

Connect adaptor and insert batteries at control panel (9/10)

Insert batteries
Remote control

7

PIR motion detector

13

Magnetic contact

17

Registration of remote control (27)

Press on control panel (24)
- KEY - PIN CODE (default code= 1234)
- ENTER = Display shows 1 user setup
- ENTER = 1-1 admin setup
- ENTER = Password

Navigate with arrow keys to 6 remote (19)
- ENTER = 6-1 learning ID
- ENTER = wait for learning

Now press OFF button on remote control
Display = learning ok = ok

= time out

= pressed too late

= ID duplicate= remote control is already registered

Press and hold ESCAPE button to leave programming mode.
Remote control is now available.

Registration of detectors (36)

Press on control panel
- KEY - PINCODE (default code=1234)-ENTER

Display shows 1 user setup

Navigate with arrow keys to 3 zone setup
- ENTER = input 3-1 ser (01-36) zone selection with number keys starting

with 01

- ENTER = wait for learning

Now press sabotage switch on detector to be registered
Display = learning ok = ok

= time out

= pressed too late

= ID duplicate= remote control is already registered

Repeat this procedure with all detectors to be registered; Combination of zones
is freely selected. Press and hold ESC button to leave programming mode.

You will find complete instructions in the manual.

Advertising
Table of contents