HOMA Installing Air Bleed Valve and Bracket - Manual

Publication
88PN3005
Please Contact Technical Support At 203-736-8890 With Any Additional Questions
Please Be Prepared To Provide Pump Serial Number During Call
Page
1 of 1
• Screw nipple assembly into motor cap using the
fittings shown in the photo at the right.
• Always apply teflon tape or water-proof thread
sealent to prevent leaks
• Place air bleed valve in the large hole in the metal
bracket.
• Screw the two bolts on the motor cap through the
holes on the “arms” of the bracket. Leave the
bracket slightly loose and moveable
• REMEMBER: The bolts on a motor cap are
frequently loctited and may need to be heated to be
removed.
• Screw the air bleed valve into the top fitting of the
nipple assembly until the bottom surface of the
valve is flush with the bracket.
• Align bolt holes in valve with bolt holes in bracket
and screw bolts completely through valve.
•
Put flat-sided washers and nuts on the end of the 5
bolts and tighten all loose nuts and bolts.
Installing Air Bleed
Valve and Bracket