AT&T PagePac Plus AmpliCenter - Manual (Page 27)

Mounting PagePac Plus AmpliCenter
NOTE: Figure 3-3 illustrates a The AmpliCenter must be securely wall mounted or installed in a standard
wall mounted configuration.
Figure 3-4 illustrates a rack
mounted arrangement.
Tools Required
19" EIA cabinet or free-standing equipment rack (Wall mount wood screws
not provided).
The following tools are required for the installation of the system hardware
and cabling.
■
Phillips screwdriver (for 10-32 screws)
■ Standard blade screwdriver (small, for terminal block connections and
level adjustments)
■ Wire strippers (24 AWG -12 AWG)
■ Telephone test set (optional, for troubleshooting)
■ Tone out circuit tester (optional, for troubleshooting)
■ Portable 70V speaker (use cabling pulled for ceiling speakers)
(optional, for troubleshooting)
■
Volt-Ohm Meter (optional, for troubleshooting)
■ 4 wood screws, if mounting on wall
SIDE VIEW FRONT VIEW
AMPLICENTER
6 FOOT
POWER CABLE
MUSIC INPUT
PAGE INTO
AMPLIFIER
Figure 3-3. Wall Mounted Hardware
3-6 Installing the Hardware