Hydra-Tech S3VHLDI User Manual

3” hydraulic submersible sludge / slurry pump, Features, Model s3vhl

Advertising
background image

MODEL S3VHL

(Aluminum Body)

MODEL S3VHLDI

(Ductile Iron Body)

3” (75 mm) Discharge

3” HYDRAULIC SUBMERSIBLE
SLUDGE / SLURRY PUMP

The S3VHL is designed to pump sludge,

slurries and liquids with stringy solids.

Uses for this pump include liquid manure

pumping, water treatment slurries and

clarifier tanks. This versatile pump is

offered in aluminum or ductile iron

construction.

FEATURES

Small Overall Size allows pump to fit

through a 20" diameter opening

Oil Lubricated Seals (can run dry)

Variable Speed hydraulic drive

Fully Recessed Vortex Impeller

(will pass 3" semi-solids)

Can be bolted directly into a pipeline or

fitted with a suction hose for underwater

dredging

Safe Hydraulic Drive can be used where

electric power is hazardous or impractical

Dependable gear type hydraulic motor

Operates with our HT15 to HT35 power

units or other hydraulic power sources

capable of flows of 10 - 18 GPM

D0413

167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website

:

www.hydra-tech.com

E-Mail

:

[email protected]

WEIGHT: (Aluminum)................................... 176 lbs. (80 kg)

(Ductile Iron)............................. 289 lbs. (131 kg)

HEIGHT:............................................................. 33" (84 cm)
WIDTH(@ widest point):............................. 19 3/4" (50 cm)
DISCHARGE:...................................................... 3", NPT(F)
INLET FLANGE:.................Drilled for 3" and 4", 125# ASA
SOLIDS HANDLING:.............................................. 3" (8 cm)
HOSE PORTS:................................................ 1" (-16) SAE
PUMP BODY: (S3VHL)................. Heat Treated Aluminum

(S3VHLDI)................................. Ductile Iron

IMPELLER:................................................... Stainless Steel
WEAR RING and WEAR PLATE.................. Stainless Steel
SHAFT:......................................................... Stainless Steel
SHAFT SEAL:.................................... Carbon/Ceramic (Std)

Silicon Carbide (Optional)

ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:.................................. Max 18 GPM (68 LPM)
OPERATING PRESSURE:............ Max 3000 PSI (204 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System

SPECIFICATIONS

Specifications are subject to change without notice

Advertising
This manual is related to the following products: