Hydra-Tech S3CSL User Manual

3” hydraulic submersible, Sand / slurry pump, Features

Advertising
background image

MODEL S3CSL

3” (75 mm) Discharge

3” HYDRAULIC SUBMERSIBLE

SAND / SLURRY PUMP

with AGITATOR

The S3CSL pump is designed to use in
applications requiring settled solids to be put
into suspension and pumped with the discharge
water. Primary applications include de-silting
ponds, lakes and streams. Other jobs may
include filling sand bags to prevent beach
erosion, tank and digester cleaning or pumping
residue from rail tank cars or barges.

FEATURES

Hardened Alloy Wear Parts

Built-in Agitator for stirring up solids

Oil Lubricated Seals (can run dry)

Variable Speed hydraulic drive

Small Size allows pump to fit through a
17 inch opening

Safe Hydraulic Drive can be used where
electric power is hazardous or impractical

Dependable gear type hydraulic motor

Operates with our HT10 to HT20 power
units or other hydraulic power sources
capable of flows to 10 GPM

B0109

167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website

:

www.hydra-tech.com

E-Mail

:

[email protected]

WEIGHT:..........................................231 lbs. (105 kg)

HEIGHT:..............................................30 1/4" (77 cm)

WIDTH (@ widest point):....................16 1/4" (41 cm)

DISCHARGE:..................................................3" NPT

SOLIDS HANDLING:..........................1 1/2" (38 mm)

HOSE PORTS:..........................1/2" and 3/4" NPT (F)

VOLUTE*:................................ Hardened Ductile Iron

IMPELLER:................................... High Chrome Alloy

WEAR PLATE............................... High Chrome Alloy

AGITATOR:...................................High Chrome Alloy

SHAFT:.........................................304 Stainless Steel

SHAFT SEALS: (upper)....................Carbon/Ceramic

(Lower)......................Silicon Carbide

HYDRAULIC OIL:.......214-320 s.s.u. @ 100°F (64°C)

INPUT FLOW:.........................Max 10 GPM (38 LPM)

OPERATING PRESSURE:....Max 3000 PSI (204 Bar)

POWER SOURCE:..

Any Open Center Hydraulic System

* Optional NI-Hard volute available for highly abrasive applications

SPECIFICATIONS

Specifications are subject to change without notice

Advertising