INSTEON Waterproof Temperature Sensor for INSTEON Wireless Thermostat (2433A3) User Manual

INSTEON Sensors

Advertising
background image

Waterproof Temperature

Sensor (2433A3)

Introduction

Package Contents

INSTEON Waterproof Temperature

Sensor is an external sensor that

wires to your INSTEON Wireless

Thermostat. When connected, the

thermostat’s LCD display will show

the sensor readings in small digits

above the thermostat’s temperature.
Waterproof Temperature Sensor can

be extended up to 100’ with 22 AWG

wire. It’s ideal for monitoring and

maintaining constant temperatures

in environments like pools, spas,

aquariums and ponds.

• One (1) 6’ INSTEON Waterproof

Temperature Sensor cable

Installation Instructions

1. Open back of Wireless

Thermostat case.

2. Locate wiring block for

temperature sensor. It should be

the right two screws (see below).

3. Use a flathead screwdriver

to loosen screws.

4. Route the sensor cable through

hole in back of thermostat case.

5. Connect the sensor’s exposed

copper wire strands to the

terminal block. Tighten screws

(see figure on next page).

NOTE: The individual wires can

be screwed into either terminal.

There is no polarity.

6. Close the back case. Unit will

automatically turn on.

Sensor

1

2

3

4

5

Advertising