Ken Tool 37032-98 Handle Replacement - Manual

CROSS-PEIN, HAND-DRILLING OR SLEDGE HAMMER
INSTRUCTIONS FOR HANDLE ASSEMBLY
Caution:
 Always wear safety goggles.
 Handles are not interchangeable. Use only the specified replacement handle for the head being
used. Using the wrong handle can cause the locking system to be damaged and allow the head
to fall off the handle.
1. Cut off old or damaged handle, as close to the hammer as possible, without cutting into the
steel.
2. Drill or chisel out some of the wood from the eye where you just cut the handle off.
3. Use a punch or chisel to drive out the remaining wood and the wedge from the eye.
4. Make sure the eye is clean from all wood chips or debris.
5. Insert the new handle from the same side you cut off the old one and drive it in tight.
6. The handle may need some minor fit adjustment to ensure it seats on the shoulder of the
handle. If this is the case, use a rasp, file or sandpaper to remove some of the wood until the
handle fits tight in the eye and seats completely on the shoulder.
7. Cut off any excess handle that has protruded through the eye and drive in the wedge flush with
the head.
HANDLE NUMBER FOR HAMMER LENGTH WEIGHT
80H-3H 37012 80H-3, 80H-4 (includes wedges) 10” 1 lb (.45 kg)
85H-3H 37023 84H-2, 84H-4, 85H-3 (includes wedges) 15” 1 lb (.45 kg)
84H-8H 37025 84H-8, 84H-10, 84H-12, 84H-16 (includes wedges) 36” 1.5 lbs (.68 kg)
84H-20 37089 84H-20 (includes wedges) 36” 1.75 lbs (.79 kg)
T11BH 35111 T11B 15” (38 cm) .75 lbs (.3 kg)
T11HN 35113 T11R, T31, T33R 15” (38 cm) .75 lbs (.3 kg)
T11CH 35119 T11C, T34, T35, T36 17” (43 cm) .75 lbs (.3 kg)
T11DH 35127 T11D 17” (43 cm) .75 lbs (.3 kg)
T11EH 35129 T11E® 30” (76 cm) 1.2 lbs (.5 kg)
T11EHS 35131 T11E® 30” (76 cm) 1.2 lbs (.5 kg)
WARNING
WHEN USING HAND TOOLS
Always wear safety goggles when using striking or struck tools.
Never use one hammer to strike another hammer.
Never use a tool with a loose or damaged handle.
Discard any striking or struck tool if tool shows dents, cracks, chips or mushrooming.
768 E. North Street, Akron, Ohio 44305 ● Phone: 888-536-8665
● Fax: 800-872-4929 ● e-mail: [email protected]
Any questions, please visit us at www.kentool.com
NEW
NEW
NEW
NEW
Part No. 37032-98