Kolpin E-Series Lights - Manual

Rev. 1
Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or (920) 928-3118 www.kolpin.com [email protected]
E-Series Lights
Parts List:
E-Series Assembly:
1. Mount the light bar using supplied brackets or your choice of aftermarket mounting options. When
mounting, always use the plastic compression bushings. Failure to do so will cause light to spin in
mounting bracket.
- If using on a 24v system, be sure to replace relay with a 24v unit
- Attach red fused wire in wiring harness to battery. Mount black eyelet to suitable ground.
- Install switch in your choice of location
- Plug light into switch
- Zip tie all wires out of harm’s way
- Test light to ensure proper function
- Limited Lifetime Warranty
Item Description Quantity
1 Light Bar 1
2 Plastic Compression Spacers 2
3 Aluminum Mounting Brackets 2
4 ¼” Nylon Nuts 2
FUSE CHART
6” 5 AMP 20” 15 AMP
10” 10 AMP 30” - 40” 20 AMP 3
1
E-Series Lights available in the
following lengths:
6” -
(P/N – 97915)
10” - (P/N – 97920)
20” - (P/N – 97925)
30” - (P/N – 97930)
40” - (P/N – 97935)
**If hooking up multiple lights use appropriate fuse**
Each 10” section requires min. 5amp of fuse protection