Cleveland Motion Controls ULTRA ISC SERIES SLIM CELL TRANSDUCER REV AA - Manual (Page 16)

U LTRA ISC S ERIES S LIM C ELL T RANSDUCER MAN-70434-0 R EV AA
2.1 M12 M ATING C ONNECTOR
The M12 connector used on the Ultra Series ISC amplifier is a four-pin, DC keyed, male
connector that mates directly with the molded cordset offered by Cleveland Motion Controls.
Table A lists the pin numbers, signal, function, wire colors and any notes that apply:
When mating the connector, align the keying
mechanism and pins so that they enter the socket
without you having to apply excessive force. Use
your fingers to sufficiently tighten the coupling nut
enough to ensure an adequate seal and to
discourage accidental loosening.
Figure 4 - Front View of M12 Connector
Supply
Signal Function
Wire
Color
Notes
1 24 VDC
Power Supply source 24
Vdc
Brown
+24 VDC
@ 35 mA max
2 +/- 10V OUT
Voltage Signal Output
Undamped bi-polar tension
signal
White max. load 2 mA
3 0V RET Power Supply Return Blue Must not exceed 25 volts from P.E.
4 COMMON Output signal Return Black
Common for +/- 10V an analog output
Must not exceed 25 volts from P.E.
Table A M12 Connector Pin #s and Signals
If you choose to make your own cables or need to repair damaged connectors, you can purchase a separate
mating connector from Cleveland Motion Controls. To order, use CMC part number, X43-34338.
A fuse with a rating of 0.25A must be used in the fixed 24 VDC supply lead to limit potential damage to the
amplifier in the event of circuit malfunction. Example: Bussman GMA-250-R
Transducers (load cells) use strain gages which have limited insulation levels to ground (earth). This requires that
the COM terminals be referenced to ground (earth) to prevent damage to the transducers (load cells).
P AGE 16 OF 42