Clock Audio CU2 - Manual

P R O F E S S I O N A L M I C R O P H O N E S Y S T E M S
An Intelligent battery management system designed for use wit
CW 9006T
 Processor controlled
 Built-In active monitoring system
 Temperature sensor
 Dedicated compartments for
charging two CW 9004T, CW
9005T or CW 9006T
 Must be used with AC power
adaptor supplied with each CU 2.
User Guide
1) Insert one or two wireless microphone transmitters in to the charger with the metal charging
points facing down. See fig 1
2) There are two LEDs. The LED closest to the power supply input is for the charging bay on the
right. The LED furthest away from the power supply input is for the charging bay on the left.
The LED will light up red to show that the
3) The transmitters are charged independently. Each transmitter may take up to 8 hours to charge
depending on the capacity of the batteries and how flat the batteries are.
4) The LED will light up green when the transmitter in that charging bay is fully charged.
5) The fully-charged transmitter can be removed and replaced with another transmitter that
requires charging, even if there is a charging transmitter in the other charging bay.
Fig 1
P R O F E S S I O N A L M I C R O P H O N E S Y S T E M S
battery management system designed for use with Clockaudio CW 9004T, CW 9005T
CW 9006T wireless base transmitters.
In active monitoring system
adaptor supplied with each CU 2.
Insert one or two wireless microphone transmitters in to the charger with the metal charging
There are two LEDs. The LED closest to the power supply input is for the charging bay on the
right. The LED furthest away from the power supply input is for the charging bay on the left.
The LED will light up red to show that the transmitter in that charging bay is charging.
The transmitters are charged independently. Each transmitter may take up to 8 hours to charge
depending on the capacity of the batteries and how flat the batteries are.
when the transmitter in that charging bay is fully charged.
charged transmitter can be removed and replaced with another transmitter that
requires charging, even if there is a charging transmitter in the other charging bay.
Turn
transmitter off
Place
transmitter in
to charging bay
Red LED
(Checking
battery and
charging)
Green LED
(Charged)
Red LED
flashing (FAULT
- battery)
Fig 2
www.clockaudio.com
CU 2
h Clockaudio CW 9004T, CW 9005T and
Insert one or two wireless microphone transmitters in to the charger with the metal charging
There are two LEDs. The LED closest to the power supply input is for the charging bay on the
right. The LED furthest away from the power supply input is for the charging bay on the left.
transmitter in that charging bay is charging. See fig 2
The transmitters are charged independently. Each transmitter may take up to 8 hours to charge
when the transmitter in that charging bay is fully charged. See fig 3
charged transmitter can be removed and replaced with another transmitter that
requires charging, even if there is a charging transmitter in the other charging bay.
Red LED
flashing (FAULT
battery)
CAUTION: Always
turn off the wireless
microphone
transmitter before
putting the
transmitter in to the
charger.
Fig 3