Codelocks KL1200 KitLock Locker Lock - Manual

CODELOCKS LTD UK
Tel: +44 (0) 1635 239645
Fax: +44 (0) 1635 239644
[email protected]
Helpline, service & spares
FREEPHONE 0800 393 405
CODELOCKS INC US
Tel: +1 714 979 2900
Fax: +1 714 979 2902
[email protected]
KitLock is a
Codelocks Ltd brand
www.codelocks.com
INSTALLATION GUIDE
Replace existing cam lock with KitLock
New Installation
A
B
Step 1 Remove existing cam lock.
Step 2 Place the 16mm ( 5 /
8
") template
hole over the hole left by the
cam lock and mark the upper
and lower fixing holes.
Step 3 Drill the two 6mm ( 1 /
4
") fixing holes.
Step 4 Fit lock to door with gasket in
place using fixing bolts. Cut bolts
to correct length. Crimp several
times with the cutting jaws of pliers,
the surplus end should break off
quite easily. Measured from
beneath the bolt head, the length
should be the door thickness, plus
approx 12mm ( 1 /
2
").
Step 1 Place template on door and mark
upper and lower 6mm ( 1 /
4
")
fixing holes and 16mm ( 5 /
8
")
spindle hole.
IMPORTANT NOTE: Before
drilling fixing holes, please
ensure the position of the
KitLock when fitted will allow
enough clearance for selected
cam to work.
Step 5 From the inside of the door
select and fit appropriate
spindle and cam using fixing
bolt. Cut bolt to suit length
of spindle plus approx
10mm ( 3 /
8
").
Step 6 Before closing the door check
the operation of the lock with
Master and User Code.
Step 7 If not changed already
CHANGE FACTORY SET
MASTER AND USER CODE
NOW!
Step 2 Drill all three fixing holes.
Step 3 Continue installation from step 4
to 7 from the Installation Guide
section A).
II-KL1200-v1:0313
Installation
Instructions
KL1
2O
O
www.kitlock.com
Vertical