CONTREX MLP-Drive - Manual

MLP-DRIVE INSTALLATION/START-UP GUIDE
CAUTION
Hazardous Voltages. Can cause severe injury, death or damage to
equipment. The MLP-Drive should only be installed by a qualified
electrician.
Proper earth grounding of all electronic equipment is required for
successful operation. Connect a low impedance earth ground to
terminal 5 of connector J3.
Separate all logic and signal level wiring (J1, J2, J4 and J5) from all
motor armature and AC power wiring (J3).
Shield all logic and signal wiring (J1, J2, J4 and J5) and terminate to
earth ground at one point only.
REQUIRED WIRING
C C C C C
O N T R E X , I N C . O N T R E X , I N C . O N T R E X , I N C . O N T R E X , I N C . O N T R E X , I N C .
SK1455 Rev 2 SK1455 Rev 2 SK1455 Rev 2 SK1455 Rev 2 SK1455 Rev 2 Page 1