Anritsu Series MS278XB User Manual
Anritsu Hardware
Advertising
Table of contents
Document Outline
- Series MS278XB High Performance Signal Analyzer Operation Manual
- Table of Contents
- Chapter 1 - General Information
- Chapter 2 - Preparation for Use
- Chapter 3 - Instrument Overview
- Chapter 4 - Front Panel Menus
- 4-1 Introduction
- 4-2 Quick Reference
- 4-3 Menu Archive
- 4-4 Parameter Entry and Measurement Setup Dialog Archive
- Occupied Bandwidth Setup Dialog
- Channel Power Setup Dialog
- Adjacent Channel Power (ACP) Setup Dialog
- Multicarrier Channel Power Setup Dialog
- CCDF Setup Dialog
- Spectrum Mask Setup Dialog
- VSA Modulation Parameters Setup Dialog
- WCDMA Graph Type Dialog
- WCDMA Setup Dialog
- TPC Limit Edge Definition Dialog
- Channel Table Editor Dialog
- Customize Tool Bar Dialog
- Options Dialog
- MATLAB Setup Dialog
- Chapter 5 - Measurements
- 5-1 Introduction
- 5-2 Basic Measurement Setups
- Setting the Center Frequency
- Setting the Frequency Span
- Setting the Start and Stop Frequencies
- Setting the Reference Level
- Setting the Input Attenuation
- Setting the Scale/Div
- Setting the Resolution Bandwidth
- Setting the Video Bandwidth
- Setting the Sweep Time
- Setting the Bandwidth Coupling Modes
- Setting Markers
- Setting Trace Modes
- Configuring the Triggering
- 5-3 Measurement Examples
- 5-4 RF Measurements
- 5-5 Modulation Measurements
- 5-6 Operation Verification
- Required Equipment
- Reference Oscillator Aging Rate (Optional)
- Frequency Readout Accuracy
- Frequency Span Accuracy
- Swept Resolution Bandwidth
- Single Sideband Phase Noise
- Average Noise Level
- Frequency Response
- Reference Level Switching Uncertainty
- Resolution Bandwidth (RBW) Switching Uncertainty
- Residual Spurious Response
- Input-related Spurious Response
- Chapter 6 - Software Peripherals
- Chapter 7 - Remote Operation
- Appendix A - Specifications
- Subject Index