Controlled Products Systems Group WKP250LM - Manual

1 2 3
4 5 6
7 8 9
* 0 #
C ncel
Carton Inventory
Overview
The Wireless Keypad uses a digitally secure intercom
link that allows it to control one access point. The
Wireless Keypad is compatible with various LiftMaster
Wireless Products.
Model WKP5LM3 can hold up to 5 PIN Numbers.
Model WKP250LM3 can hold up to 250 PIN Numbers.
Assembly
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Keypad will beep.
Keypad will continuously beep indicating no Master
PIN Number has been programmed. Proceed to Initial
Setup
.
1
Keypad
Models WKP5LM3 & WKP250LM3
Wireless Keypad
Initial Setup
Step 1: On keypad press:
Step 2: Enter 4 digit Master PIN Number.
Example: 1234.
# # #
? ? ? ?
Bolt (4)
Washer (4)
Nut (4)
Screw (4)
Allen Wrench
®
NOTE: “ * “ is the cancel button that will cancel any
call or key sequence.
Program Pre-Installed LiftMaster Receiver
Step 1: Pry open the front
panel of the receiver case
with a coin or a screwdriver.
Step 2: Press and release
the Learn button on the
receiver. The Indicator Light
will light for 30 seconds
indicating that receiver is in
Learn Mode.
Step 3: Within 30 seconds enter Master PIN Number
on Keypad.
Step 4: Press “1”.
Erase All Control Codes
Press and hold the Learn button on the receiver until
the Indicator Light turns off indicating that the receiver
memory is clear (about 6 seconds).
Indicator Light
Learn Button