Lectrosonics HM152V - Manual

HM142V/HM152V
TECHNICAL DATA
• Built in volume control
• Rugged construction for long life
The stainless steel microphone boom is mounted in a ball
HM142V
HM152V
Headset Microphones
Feature Highlights
• Worn over the head or around the neck
• Omni-directional element & adjustable mic boom for
maximum gain and minimum wind noise
• Adjustable headband cushions
joint to allow adjustment to position the microphone to the
The HM142V & HM152V headset microphones are a light- left and slightly away from the mouth.
weight design for use with a wide variety of Lectrosonics
The volume control on the temple pad is used to temporar­
wireless PA, microphone and IFB systems. The stainless
ily control feedback when used with a sound system.
steel headband and boom are adjustable for maximum
Both models are available with a locking micro plug, TA5F
comfort and flexibility.
5-pin plug, or standard 3.5mm mini plug for use with Lec-
The foam temple pads are attached to machined alumi­
trosonics wireless transmitters.
num assemblies clamped to the headband. The position
Rugged machined aluminum and stainless steel are used
of the temple pad opposite the mic boom is adjustable for
to construct the headset for years of heavy use.
a comfortable, secure fit. The stainless steel headbands
are simply shaped by hand to fit the head.
The units are the same except for the headband design.
The pickup capsule is an omnidirectional electret type,
powered by a DC bias present on the input jack of Lec­
trosonics transmitters. The omni-directional capsule
provides a wide, flat frequency response, plus ultra low
wind noise and clothing “rattle.”
Rio Rancho, NM, USA
www.lectrosonics.com