Luminex 100 User Manual Version 1.7 - Manual (Page 19)

x MAP Technology Safety
PN 89-00002-00-063 Rev. A 2 - 3
with the specific safety advisories below, in addition to adhering to
standard laboratory safety practices. The protection provided by the
equipment may be impaired or the warranty voided if the equipment
is used in a manner not specified by Luminex Corporation.
Electrical
The Luminex 100 analyzer and Luminex XYP must be connected to
approved power sources.
Do not perform any maintenance or cleaning of the system’s
electrical components (except for the fuses).
This caution label appears on the back of Luminex 100 analyzers
using the Coherent laser, and on the Luminex XYP:
Figure 2-1. Fuse Replacement Warning Label
This label appears on the back of Luminex 100 analyzers using the
Uniphase laser:
Figure 2-2. Fuse Replacement Warning Label - Uniphase Laser