Luminex xPONENT 4.2 for FLEXMAP - Manual (Page 60)

• Plate Navigation - Displays a smaller plate image for the current batch.
• Single Step - Instructs the system to acquire one well and then stop. Use this to ensure
the system is working correctly before you run the whole batch.
• Off Plate Area - Designates an alternate location for maintenance commands in the
Commands and Sequence list.
• Save Prtcl - Opens the Save Protocol dialog box to save the protocol and/or kit.
• Select Save Protocol and/or Save Std/Ctrl Kit to save the protocol and/or kit.
• Type information in the following boxes and click Save to save the protocol or kit.
• Protocol Name
• Version
• Manufacturer
• Optional Description
• Std/Ctrl Kit Name
• Std/Ctrl Kit Lot#
• Expiration
• Manufacturer
• Lots
• Save - Saves the information as a pending batch.
• Cancel - Returns to the Batches tab.
• Back - Returns to the previous window.
• Run Batch - Runs the batch and opens the Current Batch tab, where you can monitor the
batch as it runs.
Create a New Multi-Batch
Batches > Batches > New Multibatch
Use the Create a New Multi-Batch button to add or remove batches to the multi-batch set up
and to run a multi-batch.
You must ensure that the batches fit on one plate. After you add each batch, the software
automatically adds the next batch to the first well of the next column or row (depending on
your plate orientation) as long as space is available on the plate. You can also select a well
first, which places the next batch in your chosen location. If space limitations create an
overlap, an error message appears. Results for each batch are saved as individual batch
files.
NOTE: You cannot add a batch that forces multiple plates to a multi-batch
operation. When creating or adding batches, ensure your batches fit
on one plate. All batches must use the same plate name previously
defined and adjusted.
This tab contains the following:
Select Pending Batch - Contains a list of all pending batches. The list includes name,
protocol, protocol version, date, and status information for each pending batch. Select the
batch you want to add to the plate. Click OK. A plate layout diagram automatically populates
the wells for the batch. Click Add to open this box again and add additional batches.
xPONENT ® for FLEXMAP 3D ®
46