Luminex IS Version 2.3 - Manual (Page 36)

Luminex IS Software Manual for Version 2.3
x
MAP Technology
26 PN 89-00002-00-110 Rev. B
Samples Tab The Samples tab lists tests from your batch and displays the results
for each sample.
Figure 20 shows a Sample tab example listing three tests. Notice that
the left pane displays Test IL-4, IL-6 and IL-8 with Test IL-4
selected. The right pane shows the IL-4 sample results. Notice that
the well G3 location test result is “<10” and the associated
Comments column for the third sample indicates a sample out of
range error “Sample High/Low” because this sample has an MFI less
than the lowest standard in the standard curve for this non-
competitive batch.
The first sample is within the standard curve range and thus displays
an unflagged test result.
The system does not flag results as normal or abnormal according to
a defined range. Error flags only note samples that fall below or
above the standard curve.
The Comments column cells are editable and the information is
displayed in reports.
Figure 20 Analysis Window - Samples Tab Open