Luminex xPONENT 4.0 SP1 - Manual (Page 23)

11
Touring the Software
Progress. Displays a bar graph showing the progress of the current command or routine;
if the command or routine is finished, it displays a full progress bar and the command
status as Complete.
Pause. Pauses the system after the current command completes. Pause does not stop
the system in the middle of running a command. You cannot run another command while
the system is paused.
Stop. Stops the system, regardless of command status.
Eject. Ejects the plate. Once the plate is ejected, the Eject button changes to Retract.
Retract retracts the plate, and the Retract button changes back to Eject.
Temp. Displays the difference in temperature between the current reading and the reading
when it was calibrated, in degrees Celsius. If the temperature is out of tolerance, it shows
a high or low arrow. When clicked, it opens the Auto Maint tab.
Sheath Pressure. Displays the sheath pressure in psi. A high or low arrow is displayed if
the pressure is trending up or down versus the calibration pressure and it turns yellow.
When clicked, it opens the System Info tab.
XY Status. Displays the current location of the command, and the temperature of the
plate heating block in degrees Celsius. When clicked, it opens the Probe and Heater tab.
Laser. Displays the laser status, including the time remaining until you must warm up the
laser again. The Laser status button is blue. The button turns yellow when the lasers are
turned off and about ten minutes before they turn off. When clicked, it restarts the active
clock for the laser.
Region Events. Displays the number of bead events detected per second that are
classified in a region.
Total Events. Displays the number of total events detected per second.