Luminex xPONENT 4.0 SP1 - Manual (Page 42)

Luminex xPONENT 4.0 Software Manual
30
• Type a Range Name, a Low Value, a High Value, and select Inclusive if you wish to
include the low and high values in the range. Click OK to exit the dialog box.
• Units - The unit of measurement you specified in the Unit box. Click this box to type a
value for the analyte.
• Count - The total desired bead count for an analyte. Click this box to type a value. The
system continues analyzing until each bead set has met the minimum events as
determined in the Count box above. If you select the Stop after total bead count
reaches: check box and type a total count in the corresponding box, this column does
not appear.
• Region - Refers to the specific analyte selected. It is a number from 1 to 500.
Group. If you have selected Allele Call from the Analysis Type in the Settings tab, this
button displays. Click Group to group 2, 3, or 4 analytes for the group. Multiple groups can
be made.
Cancel. Click Cancel to return to the Batches tab.
Back. Click Back to return to the Settings tab.
Next. Click to go to the next tab. If the Analysis Type selected in the Settings tab was
None or Allele, this takes you to the Plate Layout tab. If the Analysis Type selected was
Quantitative or Qualitative, this button takes you to the Stds & Ctrls tab.