Luminex xPONENT 4.0 SP1 - Manual (Page 71)

59
Touring the Software
• Use External Analysis Program - Select this check-box to use a third-party program
to analyze the data. The Analysis Program list becomes active when this is selected.
• Analysis Program - Use this list to select which program to use for data analysis.
Cancel. Click to return to the main Protocol tab.
Next:. Click to advance to the Analytes tab.
Analytes Tab
Use this tab to select or edit analytes used in the batch or protocol.
FIGURE 39. Analytes Tab
This tab contains the following:
Analyte grid. A grid representing each analyte from 1 to 500. Drag the slider box at the
far left up or down, or click the blue up and down arrows to display the full range of
analytes.Select All selects all analytes, and Deselect All deselects all analytes. Click a
numbered analyte to select it; click the analyte again to deselect it. You can also click and
drag to select groups of analytes. Selected analytes are red. Deselected analytes are
gray. An analyte marked as an intra-well normalization bead is blue.
Default Analysis. The default analysis changes based on the Analysis Type you
selected in the Settings tab. You can change the analysis settings for all analytes by
clicking Change if the button is enabled in this tab. This displays the Analysis Settings
dialog box.