Luminex xPONENT 3.1 Rev 2 - Manual (Page 112)

5. Type the kit name for the exported kit into the File Name box.
6. Click Save. The dialog box closes.
Delete CAL and VER Kit Information
1. Open the Maintenance page, then open the Lot Management tab.
2. In the Active Reagents section, select the kit you want to delete from the Calibration Kit
or Performance Verification Kit lists.
3. Click Delete Kit.
CAUTION: There is no confirmation dialog box when you delete a kit.
Create Calibration Reports
1. Open the Results page, then open the Reports tab.
2. In the Report list, click Calibration Summary.
3. In the Type list, click the calibrator or verifier for which you want to create a report.
4. In the Dates list, select a start date for the date range you want to view.
5. In the Through list, select the end date for the date range you want to view.
6. Click Generate to display the desired report.
7. Use the left or right Page arrows to navigate to the different report pages.
8. Click Print to print the report, or Save to save the report.
9. Click New Report to generate another report.
Managing Sample Lists
Use the Samples page to create a sample list, view or edit sample list details, or create a
batch.
Create New Sample List
1. Open the Samples page.
2. In the Sample Lists section, select the protocol you are using for the sample list, then
click Create New Samples. The Create Sample tab opens.
3. In the ID box, type the sample ID
4. Type a patient first name in the First name box if desired.
5. Type a patient last name in the Last name box if desired.
6. To add a comment about the sample, type it in the Comment box; this is optional.
7. Click Save to add the sample to the Sample list.
8. To add more samples, click New. Repeat Steps 3-7 until you have added all of the
samples you want in your samples list.
9. Once you have added the all desired samples, click Close.
Using the Software
99