Luminex xPONENT 3.1 Rev 2 - Manual (Page 79)

FIGURE 36. Probe and Heater Tab
Move Probe Down - Moves the probe down in the specified well(s).
Plate Type - Defines the selection of either a 96-well plate or an Automated Maintenance
plate.
Plate Image - Identifies the location to be used to adjust the probe height. Clicking a well
selects it and marks it with a blue pin.
Plate Heater - Sets the temperature of the plate to the number typed in the Set Temperature
box. Up and down arrows allow half-degree adjustments of the temperature, and Apply
activates the adjustment. Current and Target temperatures display at the bottom of this
section.
NOTE: The temperature range is 35 to 60° Celsius.
WARNING: Be advised that the plate heater can become hot enough to
cause injury. Use caution when handling after heating.
System Info Tab
Use this tab to view information and diagnostics about the Luminex instrument.
xPONENT ® 3.1 Rev. 2
66