Luminex xPONENT 3.1 Rev 2 (IVD) - Manual (Page 94)

Performing Analysis
You may direct the system to acquire samples in replicate regardless of batch type. For
qualitative batches, qualitative results for replicates are averaged and the reported
interpretation is determined from this replicate average.
Analyze Current Batch
When you run a batch, the Current Batch tab opens. Here, you can view real-time analysis
of acquired analytes.
To view a single statistic type for all analytes click the statistic you want to view from the
Statistic list. To view all statistic types for a single analyte, click the analyte from the Analyte
list.
Click Single Step if you want to set the DD Gate during sample acquisition. Click Resume to
acquire the next sample. Clear Single Step if you want to run all subsequent samples without
pausing.
Manage Saved Batches
Replay Batch
You can replay a batch to reprocess batches multiple times. This function uses the data
stored in the run files from the initial acquisition to reprocess a batch and create a new batch
output file.
1. Open the Results page, then open the Saved Batches tab.
2. Click the batch you want to replay.
3. Click Replay. The Select Replay Mode dialog box opens. Click Replay batch.
4. In the Settings tab, type a batch name in the Batch Name box.
5. Type a description in the Description box.
6. Click Next.
7. On the Stds & Ctrls tab, type the appropriate information in the Standard Information
and Control Information sections. The number of Standards and/or Controls in these
sections is defined on the Settings tab in the Analysis Settings section. If your batch
uses controls, enter the appropriate values for Expected Values. Click Low Value from
the Show list, and enter the low value for each analyte. Click High Value from the Show
list, and enter the high value for each analyte. Reagent information is not required to
replay a custom batch, unless you want to use the analysis feature.
8. Click Next.
9. In the Plate Layout tab, you can do the following:
• To add well commands, choose the appropriate wells and mark them as unknown,
standard, control, background, or wash. You can also delete commands that you’ve
added, and change the starting location on the plate. If you wish to run in replicate
mode, change the Replicate Count to the appropriate number and the Grouping to
your preferred grouping method.
• To add maintenance commands, choose the desired command from the list. Choose
the well that you want to apply it to, and then choose Before Well or After Well. If you
xPONENT ® 3.1 Rev. 2 Software User Manual
84
For In Vitro Diagnostic Use