Luminex xPONENT for MAGPIX - Manual (Page 47)

• Copy All - Copies all data
• Copy - Copies only selected data
• Paste - Pastes previously copied text or data into the box
• Delete - Erases text or data from the selection
System Monitor
The System Monitor displays at the bottom of all xPONENT windows. It displays the
physical state of the Luminex system. Values are reported directly from the Luminex system.
FIGURE 15. System Monitor
1. System Status Button 2. Connection Status
3. Command Display 4. Progress Bar and Buttons
5. Eject XY Button 6. Drive Fluid Level
7. Waste Fluid Level 8. Delta Cal Temperature
9. XY Status 10. Power Off Button
System StatusButton - This button has two functions: When clicked, it opens the system
log. It also displays the current status of the system. If there are no warnings or errors, the
System Status button is green with a check mark. If there is a warning or other important
user notification, the button is yellow with an X.
Connection Status - Displays the status of the analyzer’s connection to the PC (Connected
or Disconnected). To ensure the analyzer connects to the PC, turn on the analyzer before
you start xPONENT.
Command Display - Displays the following:
• The command currently running.
• The system state (i.e. running, idle, etc.).
• Date and time.
A yellow Check Calibration button is visible in the command display if the calibration or
verification command has failed, when any verification is not current, or when the calibration
or verification was performed prior to the calibration expiration setting.
Progress - Displays a bar graph showing the progress of the current command or routine; if
the command or routine is finished, it displays a full progress bar and the command status as
Complete.
xPONENT for MAGPIX
34