Mallory Ignition Mallory PROMASTER IGNITION COILS AND VOLTMASTER MARK II IGNITION COILS 28675_28720 User Manual

Promaster, Ignition coils and voltmaster, Mark ii ignition coils

Advertising
background image

1

INSTALLATION INSTRUCTIONS

®

PROMASTER

®

IGNITION COILS AND

VOLTMASTER

®

MARK II IGNITION COILS

PART NOS. 28675, 28720, 29440 AND 29625

GENERAL INFORMATION

Check the ignition coil application to be sure it is being used in the prop-
er application for optimum performance.

Spark Plug Wires and Coil Wire:
To prevent false triggering and possibility of premature ignition failures,
use suppression type spark plug wire.

PROMASTER

®

Ignition Coils:

We recommend spiral core ignition wire, such as Mallory PRO
SIDEWINDER

®

8MM Suppression Ignition Wire or carbon core ignition

wire, such as Mallory PRO WIRE

®

8MM Suppression Ignition Wire or

Mallory SPRINT WIRE

®

8MM Suppression Ignition Wire.

VOLTMASTER

®

Mark II Ignition Coils:

We recommend carbon core ignition wire, such as Mallory PRO WIRE

®

8MM Suppression Ignition Wire or Mallory SPRINT WIRE

®

8MM

Suppression Ignition Wire.

If your coil wire will not reach between the distributor cap and the igni-
tion coil, we suggest using one of the Mallory Spark Plug Wire
Replacement Kits. The Mallory Spark Plug Wire Replacement Kit is a 4
ft. length of 8mm Silicone Jacketed Suppression Wire assembled with a
straight spark plug boot and terminal on one end, and a 90° spark plug
boot and terminal on one end. Supplied with male (HEI), and female
socket type distributor boots and terminals that make these kits ideal for
remote mounting an ignition coil.

Mallory Spark Plug Wire Replacement Kits:

• Part No. 919, PRO SIDEWINDER

®

8MM Suppression Ignition Wire

(red)
• Part No. 722, PRO WIRE

®

8MM Suppression Ignition Wire (black)

• Part No. 706, SPRINT WIRE

®

8MM Suppression Ignition Wire (yellow)

Spark Plug Gaps:
For street applications, use your engine manufacturer’s specifications.
For racing applications, start with your engine manufacturer’s specifica-
tions, then experiment with and closely monitor various gaps to achieve
maximum performance.

LIST OF PARTS:

PROMASTER

®

Ignition Coils

1 Ignition Coil

1 Ignition Coil Bracket Part No. 29227

1 Screw, #10 x 1"

1 Coil Wire Boot

1 Coil Wire Terminal

2 Ring Terminals

3 Screws, #10 x 3/4"

VOLTMASTER

®

Mark II Ignition Coils

1 Ignition Coil

1 Ignition Coil Bracket (Mounted to the coil)

1 Coil Top Kit Part No. 29218:

1 Black Plastic Cover

1 Rubber Gasket

2 Screws, 8-32 x 3/4"

2 Ring Terminals

PROMASTER

®

Ignition Coil Part Nos. 28720 and 29440 and VOLTMASTER

®

Mark II Ignition Coil Part No. 28675

are supplied with one Ignition Ballast Resistor Part No. 700.

FORM 1064 (REV. B) 9/99

Advertising