Mallory Ignition Mallory MAGNETIC BREAKERLESS DISTRIBUTOR 609 - Manual (Page 4)

AUTOMOTIVE DISTRIBUTOR SERVICE PARTS
Module Cap Rotor Cap/Rotor Kit Harness Vacuum Adv. Wire Retainer
8 Cylinder Applications With Standard Cap
42 Series
609 208M 307M 29349 29332 29314
50 Series 609 209M 309 2091M 29349
57 Series 609 209M 310 2091M 29349 29332
8 Cylinder Applications With Flat Cap
50 Series
609 221 318 29349
57 Series 609 221 318 29349 29332
(Note- 32-48 Ford- Use cap 221A instead)
8 Cylinder Applications With COMP 9000 Cap
87 Series
609 29745 29736 29349 29333-L (LH) 29744
29333-R (RH)
6 Cylinder Applications With Standard Cap (Except Semi-Even and Odd-Fire Engines)
50 Series
609 270 309 29349
57 Series 609 270 310 29349 29332
4 Cylinder Applications With Standard Cap (Except Mini Bowl)
50 Series
609 271 309 2094M 29349
57 Series 609 271 310 2094M 29349 29332
MARINE DISTRIBUTOR SERVICE PARTS
8 Cylinder Applications With Standard Cap
YLM Series
609 209D 309 29349
8 Cylinder Applications With Flat Cap
YLM Series
609 221B 318 29349
6 Cylinder Applications With Standard Cap (Except Semi-Even and Odd-Fire Engines)
YLM Series
609 270B 309 29349
4 Cylinder Applications With Standard Cap (Except Mini Bowl)
YLM Series
609 271B 309 29349
4
FIGURE 3 WIRING DIAGRAM USING MALLORY COIL 29219, 29450, 30450 ONLY
EXCEPTION: If your vehicle is equipped with a HYFIRE ® Electronic
Ignition Control or similar aftermarket ignition control, use the wir-
ing procedures and coil recommendation stated in the instructions
included with the ignition control.
SPECIAL NOTE: When using this distributor with a Mallory HYFIRE ®
or similar ignition system, you must follow the wiring diagram for
the ignition system. You should also use the correct coil as recom-
mended by the ignition control manufacturer.
The diagrams shown above are for use when the vehicle is equipped
with just a distributor and coil.
To prevent false triggering and possible
premature ignition failure, you must use
suppression type (carbon core, spiral
core, or radio suppression core) spark
plug wire.
Do not use solid core (copper core or
stainless steel core) spark plug wire
with any electronic ignition system.
ALL OTHER WIRES ORIGINALLY CONNECTED TO THE COIL (+) TERMINAL
12V/IGNITION
SWITCH
IGNITION MODULE
FEMALE CONNECTOR ENGINE
GROUND BROWN
GREEN
RED
DISTRIBUTOR WIRE HARNESS PART NO. 29349
MALLORY IS A TRADEMARK OF PRESTOLITE PERFORMANCE
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144
216.658-6416
FAX 216.688.8306 family of brands
FORM 1185 (Rev A.)
05/13
www.mallory-ignition.com MALLORY IGNITION