Little Colorado Music Table 75 - Manual

3/10
Page 1 of 2
1. Please inspect the parts for damage during shipping and for any missing items. If you suspect that there
may be damage or a shortage, call us and we will send replacement parts if needed. At this time, visualize how
the components fit together per the drawings and make sure that you have everything indentifed. This product
is finished with an environmentally friendly waterbased acrylic. It is totally non toxic and is approved for use on
children's products. There may be an odor when taken out of the box. It will dissipate more rapidly with warmer
temperature and air movement. Clean with non-abrasive cleaner and a cloth.
All musical components are replaceable and are available from Little Colorado, Inc.
2. Assemble the four legs by installing the studs in the large sides. Using a phillips screwdriver carefully
screw in each of the eight studs in the eight holes (two studs per end of each large leg). Each stud needs to be
screwed in until the shoulder is flush. Refer to cam lock illustration #1. Now attach the four legs together using
the cam locks. Check the round plastic part to be sure the arrow is pointing at the opening. Rotate all arrows if
necessary so they point toward the hole where the stud will be inserted. Insert the two studs all the way into the
plastic cam locks in the smaller leg. Now tighten the cam locks by rotating the center clockwise with a flat head
screwdriver until the arrow is pointing away from the stud. Repeat for the other three corners. The base assem-
bly should now look like illustration #2
3. Locate the four predrilled locations approximately in the middle of each side. Using a phillips screwdriver
and the1/2” wood screws install the four angle brackets loosely in the four sides. Do not tighten these screws yet
since the brackets will need to be adjusted to fit the table. Position the table top upside down on a carpeted floor.
Lower the base assembly into the grooves. The predrilled holes in the underside of the top should line up fairly
close to the brackets prevously mounted to the sides. Install the remaining four 1/2" screws through the bracket
and into the predrilled hole in the underside of the top. When these screws are tight, double check that the leg
assembly is completely seated in the grooves and then tighten the four screws that attach the bracket to the
sides.
Assembly Instructions For
Little Colorado Music Table
Stock #75
2 large and 2 small sides
1 - table top with instruments
4 - mallets
4 - maraccas
4 - metal angle brackets
8 - studs for cam locks
8 - 1/2" wood screws
1 - cymbal kit (1 - 3" machine screw, 1-2 1/4" wooden spacer,
2 lock nuts, 1 felt spacer and 1 cymbal)
You will need a standard phillips, a flat head screwdriver and a pair of pliers to complete assembly.
Contents:
Quality Children's Furniture and Accessories
Established 1987
www.littlecolorado.com
®
Inc
.
ADULT ASSEMBLY REQUIRED
Warning: Package contains small parts that present choking hazards for children.
Warning: Package contains parts with sharp points.
Warning: Package contains parts with sharp edges.
Warning: Package contains parts packed in plastic bags. Plastic bags can become a suffocation risk.