Micromod Micro-PWC: 53PW6000 MicroPWC Operators Manual - Manual (Page 108)

Micro-PWC OPERATOR’S MANUAL
94 Events
9.4.4.1 Filtering Messages by Time
Event messages displayed in the Event Historian display are shown for a specified time interval. The
default time interval uses a starting time of 19:00:00 31-Dec-1969 and an ending time of the current time
and date. The Start Time and End Time pushbuttons are used to change the start time and end time to
define the desired interval for which events are to be displayed. Click either Start Time or End Time; the
Time Selection window (
Figure 9-6 ) will appear.
Enter the time of interest in the following format:
HH:MM:SS DD-MMM-YY
Only the parameters (e.g., hours, minutes, day, etc.) which are different from the displayed default time
need to be entered. Any parameters not entered will assume the corresponding values from the default
time. The exception to this is the value for seconds, which becomes zero if not specified.
TC00546A
Figure 9-5. Event Historian Filter Window
TC00080A
Figure 9-6. Time Selection Window