Multichannel Systems Magnetic Perfusion Holder MPH - Manual

Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 2011 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
Magnetic Perfusion Holder MPH
Magnetic Perfusion Holder MPH for Perfusion Cannula
multi
channel
systems
*
Fixation screw for
- fixing the perfusion cannula inside the ball
- connecting the perfusion system to the amplifier’s ground
- a correct orientation of the cannula.
Ball with
- bore diameter for the perfusion cannula
- bore hole for the fixation screw.
Magnetic base
The strong magnetic base of the MPH will connect to any ferromagnetic surface.
Steel plates are available for all amplifier types from Multi Channel Systems MCS GmbH.
The ball has a bore hole for the fixation screw and a bore diameter with intergated
isolation tube. Please push the perfusion cannula carefully through the tube.
There is an open area in the isolation tube
for the contact between cannula and fixation
screw. If this contact is perfect, the MPH and
the perfusion cannula are connected to the
amplifier’s ground.
Fixation screw
Isolation tube
with open area
for the contact
between fixation
screw and cannula.
Important: Please do not screw the fixation screw with too much force into the ball!
Otherwise you will damage the perfusion cannula.
Schematical View of the Magnetic Perfusion Holder